masthead logo

Home | About Fylde | Applications | Products | Data Sheets | Contact Us | Search

5 Series Isolation Amplifiers.

 

5 series menu item
Bridge Amp menu item
Dynamic Strain Amp menu item
Iso Amp Menu Item
IEPE Amp Menu Item
Enclosures for 5 Series Menu Item

The FE-560-IA is a general purpose isolation amplifier for front end use when hazardous voltages must be measured with isolation mode voltage of +/- 1500 V and a signal maximum of 1000 V peak or DC.

The FE-561-IA is for front end use when hazardous voltages must be measured with isolation mode voltage of +/- 1500 V and a signal maximum of 2500 V peak or DC.

  • Ideal for power monitoring of line directly, and current, using shunts.
  • May be applied for system ground isolation with gain and attenuation as required.
  • Use with high voltage signals or small signals with high common mode voltage.
  • Galvanic isolation to 3kV pk-pk. FE-560-IA Uses advanced depletion mode FET input protection.
  • Bandwith from DC to 50 kHz with built in configurable low pass filter.
  • Low pass filter configured by plug in resistor packs.
  • Input connectors are typically sheathed banana plugs, but other connector types can be specified depending upon the application.
 

Note that remote control is not an option for these module types.

Download a FE-560-IA data sheet for a full specification :  Get DataSheet

 

Download a FE-561-IA data sheet for a full specification :  Get DataSheet

 
fe560ia picturefe560ia picture